16,000# JACK HOSE AND WIRING INSTRUCTIONS
MI91.2282
25JUN98
1
3
4
2
1.00"
5
6
3 - LOCK WASHERS
1. Install brackets and jacks using correct installation procedures. (See Installation Manual)
2. Route hose around left pivot, between cylinder and wires, then across back side of cylinder and
connect to actuator fitting.
3. Clamp hose to pivot bracket using hose clamp. Locate clamp on hose so that there is no slack in hose
when jack is folded.
4. Wire tie wires to hose 1.0" from jack. Check that the jack will fold, swing vertical and swing to the front
without damage to the hose or wire.
5. Ring terminal on warning switch must be grounded directly to frame rail.
A. Grind frame rail clean where ring terminal will be grounded.
B. Drill 1/4" hole in frame.
C. IMPORTANT: Place internal lock washers on both sides of terminal and under nut.
D. Seal both sides of bolt with silicone caulking.
6. Plug packard connector into correct wire from control box. (See Installation or Operator’s Manual)
HOSE GOES
BETWEEN
WIRES AND
CYLINDER
CHASSIS FRAME RAIL
NO SUBSTITUTION
