Husqvarna FE 450, Руководство пользователя

Страница: 52 / 128

12 SERVICE WORK ON THE CHASSIS
50
F00276-11
–
Position the brake caliper, and mount and tighten screws  .
Guideline
Screw, front brake caliper M8 25 Nm
(18.4 lbf ft)
Loctite ® 243™
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws

.
Finishing work
–
Mount the handlebar cushion.
–
Install the front fender. ( p. 52)
–
Install the front wheel. ( p. 80)
–
Install the headlight mask with the headlight. ( p. 90)
–
Check that the wiring harness, throttle cables, and brake and clutch lines can
move freely and are routed correctly.
–
Check the play of the steering head bearing. ( p. 50)
–
Remove the motorcycle from the lift stand. ( p. 45)
–
Check the headlight setting. ( p. 91)
12.11 Checking the play of the steering head bearing
Warning
Danger of accidents Incorrect steering head bearing play impairs the handling characteristic and damages components.
–
Correct incorrect steering head bearing play immediately. (Your authorized Husqvarna Motorcycles workshop will be
glad to help.)
Info
If the vehicle is operated for a lengthy period with play in the steering head bearing, the bearings and the bearing seats in
the frame can become damaged over time.
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 45)
400738-11
Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro
in the direction of travel.
Play should not be detectable on the steering head bearing.
» If there is detectable play:
–
Adjust the steering head bearing play. ( p. 51)
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the entire steering range.
There should be no detectable detent positions.
» If detent positions are detected:
–
Adjust the steering head bearing play. ( p. 51)
–
Check the steering head bearing and replace if necessary.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 45)