Husqvarna FE 450, Руководство пользователя

Страница: 45 / 128

11 TUNING THE CHASSIS
43
Guideline
Spring preload - Preload Adjuster
Comfort
+0
Standard +0
Sport +3
The adjusting wings engage noticeably at the numerical values.
Info
Adjust the spring preload to the numerical values only as the preload will
not engage between the numerical values.
Turn clockwise to increase the spring preload; turn counterclockwise to
reduce the spring preload.
Adjusting the spring preload has no influence on the absorption setting of
the rebound damping.
Basically, however, you should set the rebound damping higher with a
higher spring preload.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 45)
11.15 Handlebar position
101859-10
On the upper triple clamp, there are two holes at a distance of

to each other.
Hole distance 
15 mm (0.59 in)
The holes on the handlebar supports are placed at a distance of

from the center.
Hole distance 
3.5 mm (0.138 in)
The handlebar supports can be mounted in four different positions.
11.16 Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
101860-10
–
Remove screws

. Take off the handlebar clamps. Take off the handlebar and
lay it to one side.
Info
Cover the components to protect them against damage.
Do not bend the cables and lines.
–
Remove screws

. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount and tighten
screws

.
Guideline
Screw, handlebar holder M10 40 Nm
(29.5 lbf ft)
Loctite ® 243™
Info
Position the left and right handlebar holders evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.