Hurco AB6, Руководство по установке

Страница: 78 / 165

Installation
Autobend 6 November, 1999 2-39
5. Slide one (1) coupling hub onto the end of each of the gear
boxes and connecting shafts.
Figure 2-30. Coupling Hubs
6. Push both gauge carriages as far as possible toward the front
of the press brake to ensure left and right alignment. The
gauges should bottom out on the mounting screws.
7. Center the connecting rod assembly and install inside the
channel by aligning the blocks. Use two (2) M6 x 16 SHCS
to secure blocks. Do not tighten screws .
Important
Make sure the carriages are evenly aligned.
8. Insert the plastic disks inside the two coupling hubs of the
gear box.
9. Rotate the coupling hub so you can tighten it. The inside
holes should be on top, and the outside holes should be on the
bottom. Make sure the end of the gearbox shaft is flush with
the inboard face of the coupling.
10. Tighten the outside coupling (the top hole).
11. Slide the inside coupling hub to engage the plastic disk on the
outside coupling hub.
12. Tighten the bottom hole on the inside coupling hub.
13. Tighten the bearing support housing block’s screws.
14. Test before installing the covers. Operate with the control to
ensure the left and right gauges are the same distance from
the die.