Hurco AB6, Руководство по установке

Страница: 24 / 165

Introduction
Autobend 6 November, 1999 1-9
Hardware and Software
If the owner or an operator modifies the hardware or software by
removing, altering, disabling, or tampering with any safety circuit, safety
switch, or any safety operation and then continues to operate the AB6 with
those modifications, such operation is extremely hazardous, a foreseeable
misuse, and voids the Hurco warranty. If the owner or an operator finds
that such modifications have been made, that person must immediately
switch off the AB6 and prevent its use until it has been repaired. The
owner must then contact a Hurco service representative for assistance in
restoring the AB6 to safe operation.
Important
In many locales, machine hardware or software modification to
override safety protections and continued operation of such a
modified machine is illegal and punishable with a fine and/or
imprisonment.
Installation
The owner is responsible for proper site preparation before the AB6 is
installed as described in this manual. A Hurco Field Service Engineer or
an authorized representative must install the AB6 in the prepared location.
This location must not subject the AB6 to uncontrolled cabinet
temperatures or unfavorable work environment conditions that could cause
electronic component failure.
If the owner decides later to move the press brake from its installed
location, and if it is necessary to remove the control console from the press
brake, Hurco recommends that the owner call Hurco for assistance. Hurco
recommends that the owner use a competent rigger with the necessary
equipment to move the press brake to the desired location.