Hurco AB6, Руководство по установке

Страница: 35 / 165

Installation Manual
1-20 Revision E Hurco
Console Keypad Functions
Below are descriptions of the AB6 console keypad functions. Be familiar
with these functions before testing the system.
The AB6 control contains a display group at the top of the control where
programming entries or default values appear. There are also programming
keys with dedicated LEDs (light emitting diodes).
Values for Gauge, Ram, Job and Bend appear in the displays. Single axis
Job and Bend programming keys are below the Gauge display, and dual
axis Job and Bend programming keys are below the Ram display.
The Data Entry keys are grouped together. Use them to select tasks, scan
job and bend lists, perform calculations, select special functions, and input
numbers. Within this group of keys are the yellow Job, Bend, and New
Bend programming keys.
The keys in the Run group are the operation keys. Use them to select Auto
or Single Run mode and to jog the selected axis.
Here is the AB6 control layout:
®
P ate n ts: 4 ,4 77 ,7 54 (U S ) 1 ,10 2,43 4 (C an ad a ) 1 ,6 49 ,6 0 6 & 1 ,3 75 ,1 24 (Jap an )
O p e ratio n
LE D s
D a ta
E n try
K e ys
X -A xis
P ro g ra m m ing K e y s
O p era tio n
K e ys
O p tio n a l Y -A x is
P ro g ram m in g K e ys
D isp lay s
Figure 1-8. AB6 Control Layout