Hurco AB6, Руководство по установке

Страница: 120 / 165

Installation
Autobend 6 November, 1999 2-81
To install the advance switch on mechanical or upacting press brakes
follow these instructions:
Warning
High Voltage! To avoid potential shock hazards,
disconnect power to the power cabinet. Failure to do so
may result in serious injury.
To avoid potential injury turn off the press brake, and
install the Out of Service tag and the lockout device.
Prevent component damage by discharging static
electricity to a ground.
•
Before touching, adjusting, or removing a PC
board, wear a wrist strap grounded to the cabinet
or enclosure ground point.
•
If a grounding wrist strap is not available, touch
a grounded point within the enclosure each time
before touching a PCB or electronic assembly.
An example of a grounding point is the metal
cabinet’s screws.
Follow the procedures below:
1. Disconnect power to the press brake.
2. Remove the rear covers from the upacting press brake (not
the mechanical press brake) to access its interior.
3. Position the advance switch to a clean mounting surface
next to either:
•
the foot treadle on upacting press brakes, or
•
the Pitman assembly on mechanical press brakes.
4. Mark the centerline of the advance switch mounting holes.
See the appropriate Advance Switch figure shown
previously:
Advance Switch Mounting for Mechanical Press Brakes
Advance Switch on Upacting Press Brakes.
5. Drill two (2) holes with a #24 bit and tap for a #10-24
thread.