HunterDouglas Skyline PowerView, Установка Эксплуатация Уход

Страница: 11 / 60

INSTALLATION
9
Inside and Ceiling Mount Applications WITH A Valance
■
Refer to the appropriate section below for your valance type:
➤
Metal Valance with Returns — below
➤
Metal Valance without Returns — page 10
➤
Fabric Valance with Returns — page 11
➤
Fabric Valance without Returns — page 14
➤
Fabric-Wrapped Large Cassette — page 21
➤
To mount your valance outside the window casement or to the wall — page 26
IMPORTANT:
The assembled valance serves as a drilling template when marking the screw
holes on the sill or ceiling.
Metal Valance with Returns
■
Assemble the valance corners and returns.
➤
Fit the tabs on the corner end caps into
the notches on the end of the valance
piece.
➤
Fit the tabs on the corner end cap into
the notches on the end of the valance
return pieces.
■
Snap the valance brackets onto the valance, spacing them 2" to 4" from each end with 18"
to 24" between intermediate valance brackets.
■
Center the valance inside the window opening (inside mount) or over the window opening
(ceiling mount).
■
Mark the drilling locations, using the valance clip holes as guides.
■
Set the valance aside.
■
Drill the holes at the mounting clip locations previously marked.
CAUTION: Do not mount into drywall, only mount into wood.
■
Holding the valance in place over the
drilled holes, insert a screw through each
mounting clip and valance bracket. Ensure
that the RELEASE TAB FACES THE WALL.
Proceed to “Mount the Headrail” on page 23.
Valance
(Front of
the Unit)
Tabs
Valance
Return
Corner
End Cap
Notches
1
2
Intermediate
Valance Brackets
Valance Clip Hole
2"-4" 18"-24" 2"-4" 18"-24" 18"-24"
Valance Return
Jamb Jamb
Room Wall
Valance Mounting
Bracket
Mounting Clip
Mounting
Screw
Release Tab