Hunter Douglas Douette PowerView, Установка Эксплуатация Уход

Страница: 29 / 44

OPERATION
27
Testing the Shade
Testing the shade with the manual control
button will allow you to ensure that the motor
and power source are working correctly.
■ ■
Press the manual control button on the
headrail to test operation. If the shade
does not operate, see “Troubleshooting”
on page 35.
■ ➤
Press the button to alternately traverse
closed, stop, and traverse open
the shade.
Using the PowerView
™
Remote
First, activate the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT: If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
™
Shade Network” in the PowerView Motorization Remote Control Guide .
Joining a Shade to a Group
IMPORTANT: The shade will not operate using the remote until it has been joined to a group.
1. Press and hold
■
STOP for 4 seconds to put the remote in program mode. The lights on the
remote will flash to indicate it is in program mode.
2. Press the desired group number (1 – 6) on the remote. The backlight for the group number
will flash to show it is selected.
3. Press and hold the manual control button on the shade.
4. While continuing to press the manual button, press
▲
OPEN on the remote. The shade will
move slightly to indicate it has joined the group. Release the manual control button.
5. Press and hold
■
STOP for 4 seconds to exit program mode. The lights will stop flashing.
Group 1
Group 2
OPEN
CLOSE
Group 3
Group 4
Group 5
Group 6
Favorite
(Shade position)
LEFT ARROW
No function (only used
for vaned products or
Top-Down/Bottom-Up)
RIGHT ARROW
No function (only used for vaned
products or Top-Down/Bottom-Up)
STOP
(Press and hold for
programming mode)