Hunter Douglas Douette PowerView, Установка Эксплуатация Уход

Страница: 7 / 44

INSTALLATION – OUTSIDE MOUNT
5
Outside Mount
Mount the Installation Brackets
■ ■
Center the headrail over the window opening at the desired height. Use a pencil to mark
each end of the headrail. (On the stacking side, the end of the white gearbox counts as the
end of the headrail.)
■ ➤
Alternatively, measure the width of the headrail and use that width to mark the headrail
end points.
■ ■
Mark end bracket locations 8" in from each end of the headrail.
■ ➤
Mark the locations of any additional brackets, spaced evenly between the two end
brackets. Mount into wood whenever possible.
■ ■
Determine where to place the top of the installation brackets.
■ ➤
Add the desired floor clearance to the ordered
height of the shade. The ordered height can be
found on the packaging label. A minimum of
1
/
2
"
floor clearance is recommended.
■ ➤
Measure the total distance up from the floor. This is
where to place the top of the installation brackets.
■ ➤
A minimum flat vertical surface of 1
1
/
4
" is required
to mount the brackets.
CAUTION: The rear of the brackets must be flush
against a flat mounting surface. Do not mount
brackets on curved molding.
■ ■
Center the brackets on your marks and mark the screw holes.
■ ➤
When using extension brackets, mark two screw holes
per bracket.
Headrail End Marks
Window/Door Opening
8" 8" Space Evenly Space Evenly
Floor Clearance
Top of
Bracket
Ordered
Shade
Height