Hudson 1948 Commodore, Руководство по обслуживанию

Страница: 8 / 147

3 BODY MANUAL
DOOR WINDOW REGULATOR -
REAR
(Models 1C, 1D, 2C, 2D and 3D)
REMOVAL
1. Remove door trim panel. See "Trim Panel Removal".
2. Cut inner panel as shown in Figure 5, to expose
screws (G) and (H).
3. Remove the one screw (G).
4. Remove retainer clip from the regulator arm to
window glass control.
5. Raise the door glass, insert a drift or punch through
the opening where screw (G) has been removed.
The drift should be so placed below glass channel to
hold glass in a raised position when regulator is
removed.
6. Remove screws (H) attaching regulator to door
inner panel and remove the regulator through open-
ing at bottom of door.
FIGURE 5
INSTALLATION
Reverse procedure of removal and repair door inner
liner.
DOOR GLASS - FRONT
(All Models 1948 thru 1954
Except 1C, 1D, 2C, 2D and 3D)
)
REMOVAL
1. Remove safety lock knob and garnish moulding.
2. Remove small wood block (on cars so equipped).
3. Remove trim panel, see "Trim Panel Removal".
4. Cut door inner liner as shown in Figures 1 and 2.
5. Remove screw (A) and two screws at (B). 6. Remove
center glass channel (D) or lower it into the door.
7. Tilt glass inward and raise to upper limit of regulator.
8. Release regulator cross arms from glass channel and
remove glass and glass channel.
INSTALLATION
Reverse procedure of removal.
DOOR GLASS - FRONT
(Models 1C, 1D, 2C, 2D and 3D)
REMOVAL
1. Remove door trim panel. See "Trim Panel Removal",
Page 1.
2. Cut inner liner as shown in Figure 3, to expose screws
(D).
3. Remove the two screws (D) attaching center bar glass
run to door inner panel.
4. With the door glass in the down position, remove the
retainer clip from the regulator arm.
FIGURE 6
5. Remove regulator arm from glass channel, bring the
door glass down and at the same time turn the glass
1/4 turn to bring the narrow side of glass to the top,
as shown in Figure 6. Tilt glass inward and remove
through the top opening in door.