Hudson 1948 Commodore, Руководство по обслуживанию

Страница: 35 / 147

BODY MANUAL 30
FIGURE 60
1. Insert the new glass, working lips of weatherstrip recess
up over edge of glass until glass, is completely encased,
Figure 60.
FIGURE 61
NOTE: To facilitate assembly of the new glass on the 500
models, place a block of wood under the window center
bar, Figure 61.
FIGURE 62
2. After the window is installed in the weatherstrip channel
(500 series), tighten the center moulding retainer screws.
3. Carefully slide the reveal mouldings onto the weatherstrip.
FIGURE 63
4. Install moulding joint covers, Figure 62.
5. Apply a thin coat of rubber cement to the reveal
mouldings and 1-1/2" high on the glass completely
around the glass.
6. After rubber cement becomes tacky, place pieces of 2"
masking tape vertically and horizontally tying the
reveal mouldings and glass as a unit. Place strips 8"
apart, Figure 63. To further insure a good tight assem-
bly, place a strip of masking tape completely encircl-
ing the window and reveal moulding.
7. Apply a ribbon of weatherstrip sealer to the body
recess channel in the weatherstrip. Allow only enough
sealer to fill the channel recess. (Use a thin piece of
wood approximately 3/4" wide to remove excess
sealer from the weatherstrip and also to force the
sealer into the weatherstrip recess.)
8. Tie a stout cord (Mason line) around the rear window
weatherstrip (between the inside body rubber lip and
lip of recess). Tie cord tightly enough to draw the
inner edges of the rubber c h a nn e 1 within the limits
of the body rear window opening. Tie cord at bottom
of window. Leave sufficient cord to provide a good
hand hold to pull the cord; tape loose ends to window
glass to prevent interference when installing the win-
dow assembly.
9. Place masking tape around the window recess at
inside of body to protect headlining, Figure 63.
10. Apply liquid soap on the inside of the large lip of the
weatherstrip and around the body recess lip.
11. With one man inside the car and one man on each
side of the car (outside), insert the window from the
outside, positioning glass evenly around window
opening with lower edge of weatherstrip over lip of
bottom flange in window opening.