Hudson 1948 Commodore, Руководство по обслуживанию

Страница: 19 / 147

BODY MANUAL 14
NOTE: Support bracket and check arm to prevent dis-
torting the bracket or arm.
3. Tighten door hinge screws securely and check door
adjustment as outlined in Manual, Pages 11 and 12.
4. Install hinge pocket covers (D) and (E) and fill hinge
pockets above and below hinges with body caulking.
Sealer must not project beyond edges of hinge pockets.
NOTE: These hinge pockets can be installed on cars not
so equipped except 1C, 1D, 2C, 2D and 3D. See Figures
24 and 25 for drilling instructions. (Insert (1) for the
upper pocket and insert (2) for the lower pocket.)
FIGURE 25
DOOR CHECK ARM
(All Models 1948 thru 1954)
REMOVAL
1. Remove trim panel. See "Trim Panel Removal", Page 1.
2. D r i 11 out door check arm rivet, using a 1/4" drill.
3. Push door check arm inward and remove through bottom
opening in door inner panel.
INSTALLATION
Reverse procedure of removal. Using a new rivet peen
securely.
NOTE: If rubber bumper is deteriorated or spring is
damaged, replace with a new assembly.
DOOR FRONT PILLAR SEALS
(All Models 1948 thru 1954
Except 1C, 1D, 2C, 2D and 3D)
REPLACEMENT
1. Remove two Phillips head screws at front of scuff plate,
Figure 24.
2. Remove eight Phillips head screws attaching pillar seal
to front pillar.
3. Remove all cement and permagum at hinge pockets (H).
4. Apply a coat of weatherstrip adhesive to the attaching
surface of the front pillar weatherstrip and allow adhe-
sive to set for a few minutes before installing the weath-
erstrip.
5. Apply a strip of permagum in each hinge pocket . The
permagum sealer must not extend beyond area of pillar
weatherstrip.
6. Install pillar weatherstrip entering bottom of weather-
strip under scuff plate and installing the weatherstrip
lower screw first. Align weatherstrip with other holes.
NOTE: If it is necessary to drill additional holes in the
pillar on some of the early 480 series cars, use the weath-
erstrip as a template and drill holes as required using a
No. 34 drill (.111").
7. When the pillar seal (weatherstrip) is installed, apply a
bead of Body Sealer in base of the "V" formed by the
pillar face and weatherstrip lip beginning at top of the
weatherstrip, and continuing down to the lower hinge
and over the outer surface of lower hinge continuing to
end of weatherstrip.
NOTE: When replacing the pillar seals always check
front of scuff plate to make sure seal has not been broken
at that point.
DOOR OPENING WEATHER-
STRIP - UPPER
(All Models 1948 thru 1953
Except 1C, 2C)
REMOVE AND REPLACE
1. Remove the upper door opening weatherstrip, Figure
26.