Hudson 1948 Commodore, Руководство по обслуживанию

Страница: 72 / 147

67 BODY MANUAL
ENGINE HOOD
(All Models 1948 thru 1954
Except 1C, 1D, 2C, 2D and 3D
)
REMOVAL
1. Raise hood and place prop under front of hood.
2. Remove two hood prop bolts (2), Figure 98, (one on each
side). Hood props (3) remain attached to fender side dust
shields (11), on models so equipped.
3. Remove the two hood hinge bolts, (7 and 8), from each
side at rear of hood.
4. With a helper, remove hood from car.
INSTALLATION
Reverse procedure of removal and adjust at hood hinge
bolts.
FIGURE 98
HOOD ADJUSTMENT
(All Models 1948 thru 1954
Except 1C, 1D, 2C, 2D and 3D)
1. Loosen the two bolts, (9 and 10), Figure 98, which attach
the hood hinge to the cowl just enough to allow for back-
ward or forward movement.
2. Loosen screws (7 and 8) attaching hinge arm to hood,
(each side).
NOTE: Forward and backward adjustments and up
and down adjustments can now be made at the rear
of the hood. Up or down adjustments at the front of
the hood can be made by raising or lowering the three
rubber bumpers mounted on the front fender tie
panel and adjusting the spring retainer bolt mounted
on the hood lock upper support
.
3. After all adjustments have been made, tighten all bolts
and locknuts securely.
FIGURE 99
HOOD LOCK UPPER SUPPORT (All
Models 1948 thru 1950)
REMOVAL
1. With a screwdriver remove the spring retainer bolt (2)
from the attaching nut and remove retainer and spring,
Figure 99.
2. Remove the four attaching nuts and washers (1) from
lock support plate.
3. Remove the two sheet metal screws from bracket at rear
of assembly and slide assembly to one side and remove.
INSTALLATION
Reverse procedure of removal. Adjust locking spring by
turning slotted retainer assembly to left or right.