Hudson 1948 Commodore, Руководство по обслуживанию

Страница: 12 / 147

7 BODY MANUAL
DOOR LOCK - FRONT
(Models 1C, ID, 2C, 2D and 3D)
REMOVAL
1. Remove door trim panel, see "Trim Panel Removal",
Page 1.
2. Cut inner liner as shown in Figure 3, to expose screws (D).
3. Remove window glass - follow operations (3), (4) and (5)
under "Door Glass Removal" .
4. Remove retainer clip from door lock cylinder, see "Lock
Cylinder Removal", Figure 11.
5. Remove retainer spring (A), attaching the remote control
link to door lock, Figure 12.
6. Remove two screws (H), attaching the upper door frame
to door assembly.
FIGURE 12
7. Remove three screws (F), attaching the door lock to door
assembly.
8. From inside of door, pull back on upper door frame, push
door lock inward and down.
9. Turn lock 1/4 turn to by-pass upper door frame anchor
plate and remove lock through bottom opening in door.
INSTALLATION
1. Reverse procedure of removal, repair door inner liner.
2. Install door trim panel. See "Trim Panel Installation".
DOOR LOCK - REAR
(Models 1C, 1D, 2C, 2D and 3D)
REMOVAL
1. Remove door trim panel. See "Trim Panel Removal".
2. Cut inner liner as shown in Figure 5, to expose screws (D),
(E), (F) and (J).
3. Remove retainer spring (D), attaching remote control link
to door lock.
FIGURE 13
4. Remove screw (A) attaching lock release rod pivot to door
inner panel, Figure 13.
5. Remove cotter pin attaching lock connector rod to pivot.
6. Remove screw (F) attaching wing frame to door inner panel.
7. Remove two screws (J) attaching center bar glass run to
door inner panel.
8. Cut weatherstrip at (C) as shown in Figure 13.
9. Remove two screws at (A) and the three screws at the front
section of the door attaching the upper door frame to the
door assembly.