Huawei Quidway S6500 Series, Руководство по управлению

Страница: 726 / 845

Command Manual - System Management
Quidway S6500 Series Ethernet Switches
Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-25
Note:
If you only specify the level for one/two of the three types of information, the level(s) of
the unspecified two/one return(s) to the default. For example, if you only define the
level of the log information, then the levels of the trap and debugging information return
to the defaults.
channel-number : Channel number to be set.
channel-name : Channel name to be set. The name can be channel6, channel7,
channel8, channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer.
state : Set the state of the information.
state : Specify the state as on or off .
Description
Using info-center source command, you can add/delete a record to the information
channel. Using undo info-center source command, you can cancel the contents of
the information channel.
For example, for the filter of IP module log output, you can configure to output the logs
at a level higher than warnings to the log host and output those higher than
informational to the log buffer. You can also configure to output the trap information on
the IP module to a specified trap host, etc.
The channels for filtering in all the directions are specified by this configuration
command. All the information will be sent to the corresponding directions through the
specified channels. You can configure the channels in the output direction, channel
filter information, filtering and redirecting of all kinds of information.
At present, the system distributes an information channel in each output direction by
default, shown as follows:
Table 4-3 Information channel in each output direction by default
Output direction Information channel name
Console console
Monitor monitor
Info-center loghost loghost
Log buffer logbuffer
Trap buffer trapbuffer
snmp snmpagent