HT Italia SOLAR300, Руководство пользователя

Страница: 7 / 160

SOLAR300 - SOLAR300N
EN - 5
1.3. DURING USE
Please read carefully the below points:
CAUTION

Should you fail to keep to the prescribed instructions you could damage
the instrument and/or its components or endanger your safety

Do not touch any unused terminal when the meter is connected to the
circuit on test

When measuring current, other currents located near the leads may affect
the measuring accuracy

When measuring current, always position the wire in the very middle of the
jaws in order to obtain the highest accuracy

A measured value remains constant if the " HOLD " function is active.
Should you notice that the measured value remains unchanged, disable
the “
HOLD ” function
1.4. AFTER USE

After use, turn off the instrument by pressing ON/OFF key for a few seconds.

If you expect not to use the instrument for a long time please keep to the storage
instructions described at § 3.3.
1.5. MEASURING (OVERVOLTAGE) CATEGORIES DEFINITIONS
IEC/EN61010-1: Safety requirements for electrical equipment for measurement, control
and laboratory use, Part 1: General requirements, gives a definition of measuring
category, usually called overvoltage category. § 6.7.4: Measuring circuits:
(OMISSIS)
Circuits are divided into the following measurement categories:

Measurement category IV is for measurements performed at the source of the low-
voltage installation
Examples are electricity meters and measurements on primary overcurrent protection
devices and ripple control units

Measurement category III is for measurements performed in the building installation.
Examples are measurements on distribution boards, circuit breakers, wiring, including
cables, bus-bars, junction boxes, switches, socket-outlets in the fixed installation, and
equipment for industrial use and some other equipment, for example, stationary
motors with permanent connection to fixed installation

Measurement category II is for measurements performed on circuits directly
connected to the low voltage installation
Examples are measurements on household appliances, portable tools and similar
equipment

Measurement category I is for measurements performed on circuits not directly
connected to MAINS
Examples are measurements on circuits not derived from MAINS, and specially
protected (internal) MAINS-derived circuits. In the latter case, transient stresses are
variable; for that reason, the norm requires that the transient withstand capability of the
equipment is made known to the user