Repair Information
111
Edge Switch 2/12 Service Manual
Clean Fiber-Optic Components
Perform this procedure as directed in this publication and when connecting or
disconnecting fiber-optic cables from port optical transceivers (if necessary). To
clean fiber-optic components:
1. Obtain the appropriate tools (portable can of oil-free compressed air and
alcohol pads) from the fiber-optic cleaning kit.
2. Disconnect the fiber-optic cable from the transceiver. Use compressed air to
blow any contaminants from the connector, as shown in part A of
.
a.
Keep the air nozzle approximately 50 millimeters (two inches) from the
end of the connector and hold the can upright.
b.
Blow compressed air on the surfaces and end of the connector
continuously for approximately five seconds.
Figure 25: Clean fiber-optic components
3. Gently wipe the end-face and other surfaces of the connector with an alcohol
pad as shown in part B of
. Ensure the pad makes full contact with
the surface to be cleaned. Wait approximately five seconds for surfaces to dry.
4. Repeat
step 2
and
step 3
of this procedure (second cleaning).
5. Repeat
step 2
and
step 3
of this procedure again (third cleaning), then
reconnect the fiber-optic cable to the port.
A
B
Содержание StorageWorks Edge Switch 2/12
Страница 16: ...About this Guide 16 Edge Switch 2 12 Service Manual ...
Страница 124: ...Repair Information 124 Edge Switch 2 12 Service Manual ...
Страница 132: ...Illustrated Parts Breakdown 132 Edge Switch 2 12 Service Manual ...
Страница 172: ...Event Codes 172 Edge Switch 2 12 Service Manual ...
