HP D2D100, Руководство пользователя

Страница: 32 / 176

Connecting the hardware
1. Power connector
2. LAN port 1 connector, must be connected
3. LAN port 2 connector
Figure 11 Network and power connectors
1.
Use the supplied power cord to connect the HP D2D Backup System to the main power supply. This
HP-approved cord is appropriate for your speci fi c geographic region.
For detailed safety information, see the Safety Guide on the HP StorageWorks D2D Backup System
CD-ROM.
2. Use any CAT-5E network cable (also supplied with the product) to connect to a Gigabit network
switch. 100 Base-T Ethernet will limit performance; 10 Base-T Ethernet will severely limit performance.
See also “ Dual network ports ” on page 32.
NOTE:
The Web Management Interface is used to con fi gure devices and it requires an Ethernet connection.
LAN Port 1 (the lower LAN port on the rear of the HP D2D) must always be connected.
NOTE:
The HP D2D also supports direct connection of a monitor and keyboard. Please refer to
“ Using the system console to discover the HP D2D ” on page 47 for more information about this.
Supported Ethernet con fi gurations
Ethernet network connection
IPv4 and IPv6 network protocols
The HP D2D supports both IPv4 and IPv6. Setup and con fi guration will default to IPv4, if the
network is con fi gured to support it. On an IPv6–only network, it is normally suf fi cient to enter
the IPv6 MAC Address (found on the label on the top of the unit) when running the Installation
Wizard. However, if this does not work, you can use the system console, as described in
“ Using the system console to discover the HP D2D ” on page 47.
Dual network ports
The two physical network ports provide three network con fi guration modes:
• Single Port Con fi guration: The HP D2D is connected to one network only; only one network port
is used (Port 1).
• Dual Port Con fi guration: The HP D2D is connected to two different networks. Both network ports
are used.
32
Connecting and installing the HP D2D Backup System