HP D2D100, Руководство пользователя

Страница: 28 / 176

WARNING!
These rails, when installed, form only a shelf for the server to rest on. The server is not attached to the rail
by any other means. Use extreme caution when pulling the server out from the rack; it can slip and
fall, causing damage to the server or injury. HP is not responsible for any damage or injury caused by
the mishandling of the server.
WARNING!
Ensure that the rack is level and stable before working on the rack. Be sure the leveling jacks (feet) extend
to the fl oor and that the full weight of the rack rests fi rmly on the fl oor.
WARNING!
Ensure that the rack has anti-tip measures in place. Such measures may include fl oor-bolting, anti-tip
feet, ballast, or a combination of these as speci fi ed by the rack manufacturer and applicable codes.
WARNING!
Ensure that suf fi cient personnel are on hand to support the product(s) during the installation process. Use
of the appropriate lifting device is recommended as an installation aid.
WARNING!
Always load the rack from the bottom up. Load the heaviest items in the rack fi rst. This makes the rack
bottom-heavy and helps prevent it from becoming unstable.
WARNING!
Do not overload the branch circuit that provides power to the rack. The total rack load should not
exceed 80 percent of the branch circuit rating.
Mounting the server
1. Position left and right rack rails at the desired ’U’ position in the rack.
NOTE:
The rails can be adjusted to fi t the rack.
2. Secure rack rails to the front and back rack columns using screws. Make sure that the shoulders
of the screws fi t inside the square or round holes of the rack.
NOTE:
If installing rails into a square hole rack, use larger-sized shoulder screws and pins for mounting. If
installing rails into a round hole rack, use smaller-sized shoulder screws and pins for mounting.
28
Connecting and installing the HP D2D Backup System