HP BL536A, Руководство пользователя и обслуживания

Страница: 24 / 165

Mounting the device in a rack
If you plan to set the Autoloader on a table or rack shelf, skip this step and continue with Installing
the Tabletop Conversion Kit (page 25) .
WARNING! The HP StorageWorks 1/8 G2 Tape Autoloader weighs 11.5 kg (25.4 lb) without
media and 13.1 kg (28.9 lb) with media (8 cartridges). When moving the Autoloader, to reduce
the risk of personal injury or damage to the Autoloader: 1) observe local health and safety
requirements and guidelines for manual material handing, 2) always remove all tapes to reduce
the overall weight of the Autoloader, and 3) obtain adequate assistance to lift and stabilize the
Autoloader during installation or removal.
The device easily installs into the HP Rack System/E, or the HP Rack 5000 or HP Rack 10000
series. You need a #2 and a #3 Phillips screwdriver for this procedure.
Unpack the rack kit and verify that it includes the following:
Figure 13 Rack kit
•
Two rails
•
Two bags of eight M6 screws.
Select the bag of screws appropriate for your type of rack.
•
The HP Rack System/E rack has 7.1 mm round holes in the rack column. The packet for this
rack type is labeled
HP Rack System/E .
•
The HP Rack 5000 and 10000 series have 9.5 mm square holes in the rack column. The
packet for these rack types is labeled
HP Rack 5000, 10000 Series.
To install the rails into the rack:
1.
Using the screws for your rack type and a #3 Phillips screwdriver, secure one rail to each
side of the rack in your chosen rack location.
2. Secure the front of one rail to the front of the rack. Extend the rail to the depth of the rack and
secure the rail to the back of the rack. The front of the rails are straight and the back are
angled, as shown in
Installing the rails into the rack (page 24) .
Figure 14 Installing the rails into the rack
24 Installing the Tape Autoloader