HP 9124 - Cisco MDS Fabric Switch, Руководство по настройке

Страница: 1112 / 1444

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
43-6
Cisco MDS 9000 Family CLI Configuration Guide
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 43 Configuring IP Services
IPFC
IPFC
IPFC provides IP forwarding or in-band switch management over a Fibre Channel interface (rather than
out-of-band using the Gigabit Ethernet mgmt 0 interface). You can be use IPFC to specify that IP frames
can be transported over Fibre Channel using encapsulation techniques. IP frames are encapsulated into
Fibre Channel frames so NMS information can cross the Fibre Channel network without using an overlay
Ethernet network.
Once the VSAN interface is created, you can specify the IP address for that VSAN. You can assign an
IPv4 address or an IPv6 address.
Note See the Chapter 46, “Configuring IPv6 for Gigabit Ethernet Interfaces” for information about
configuring IPv6 on the Cisco MDS 9000 Family switches.
This topic includes the following sections:
•
IPFC Configuration Guidelines, page 43-6
• Configuring an IPv4 Address in a VSAN, page 43-7
•
Verifying the VSAN Interface Configuration, page 43-7
• Enabling IPv4 Routing, page 43-7
•
Verifying the IPv4 Routing Configuration, page 43-7
• IPFC Configuration Example, page 43-8
IPFC Configuration Guidelines
Follow these guidelines to configure IPFC:
1. Create the VSAN to use for in-band management, if necessary.
2.
Configure an IPv4 address and subnet mask for the VSAN interface.
3.
Enable IPv4 routing.
4.
Verify connectivity.
Step 2
switch(config)# ip default-network 190.10.1.0
Configures the IPv4 address for the
default network (190.10.1.0).
switch(config)# ip route 10.0.0.0 255.0.0.0 131.108.3.4
switch(config)# ip default-network 10.0.0.0
Defines a static route to network
10.0.0.0 as the static default route.
Command Purpose