HP 9124 - Cisco MDS Fabric Switch, Руководство по настройке

Страница: 474 / 1444

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
18-6
Cisco MDS 9000 Family CLI Configuration Guide
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 18 Scheduling Maintenance Jobs
Configuring the Command Scheduler
Deleting a Job
To delete a job for the command scheduler, follow these steps:
Specifying a Schedule
After defining jobs, you can create schedules and assign jobs to the schedule. Subsequently, you can
configure the time of execution. The execution can be one-time or periodic depending on your
requirements. If the time for the schedule is not configured, then it will never be executed.
Specifying a Periodic Schedule
When you specify a periodic job execution, that job is executed periodically at the specified (daily,
weekly, monthly, or delta) intervals.
To specify a periodic job for the command scheduler, follow these steps:
Command Purpose
Step 1
switch# conf t
switch(config)#
Enters the configuration mode.
Step 2
switch(config)# no scheduler job name addMemVsan99
Deletes a defined job and all commands
defined within that job.
Command Purpose
Step 1
switch# conf t
switch(config)#
Enters the configuration mode.
Step 2
switch(config)# scheduler schedule name
weekendbackupqos
switch(config-schedule)#
Defines a job schedule (weekendbackup) and enters
the submode for that schedule.
switch(config)# no scheduler schedule
name weekendbackup
Deletes the defined schedule.
Step 3
switch(config-schedule)# job name
offpeakZoning
switch(config-schedule)# job name
offpeakQOS
Assign two jobs offpeakZoning and offpeakQOS for
this schedule.
Step 4
switch(config-schedule)#
no job name
addMem99
Deletes the job assigned for this schedule.
Note
The following examples are only provided for reference.