HP 9124 - Cisco MDS Fabric Switch, Руководство по настройке

Страница: 1120 / 1444

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
43-14
Cisco MDS 9000 Family CLI Configuration Guide
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 43 Configuring IP Services
Multiple VSAN Configuration
To configure an overlay VSAN in one switch (using
the example in
Figure 43-4
),
follow these steps:
To configure the NMS station displayed in Figure 43-4 , follow this step:
Multiple VSAN Configuration
More than one VSAN can be used to segment the management network in multiple subnets. An active
interface must be present on the switch for the VSAN interface to be enabled.
To configure multiple VSANs, follow these steps:
Step 1 Add the VSAN to the VSAN database on any switch in the fabric.
Step 2
Create a VSAN interface for the appropriate VSAN on any switch in the fabric.
Step 3 Assign an IP address on every VSAN interface on the same subnet as the corresponding VSAN.
Step 4
Define the multiple static routes on the Fibre Channel switches and the IP cloud (see Figure 43-5
)
.
Command Purpose
Step 1
switch# config t
Enters configuration mode.
Step 2
switch(config)# vsan database
switch-config-vsan-db#
Configures the VSAN database.
Step 3
switch--config-vsan-db# vsan 10 name MGMT_VSAN
Defines the VSAN in the VSAN database on
all of the switches in the Fibre Channel fabric.
Step 4
switch--config-vsan-db# exit
switch(config)#
Exits the VSAN database mode.
Step 5
switch(config)# interface vsan 10
switch(config-if)#
Creates a VSAN interface (VSAN 10).
Step 6
switch(config-if)# ip address 10.10.10.0
netmask 255.255.255.0
Assigns an IPv4 address and subnet mask for
this switch.
Step 7
switch(config-if)# no shutdown
Enables the configured interface.
Step 8
switch(config-if)#
end
switch#
Exits to EXEC mode.
Step 9
switch# exit
Exits the switch and returns to the NMS. In
this example the NMS is assumed to be on the
same subnet of the Ethernet management
interface of the edge that provides access to
the Fibre Channel fabric.
Command Purpose
Step 1
nms# route ADD 10.10.10.0 MASK 255.255.255.0
172.22.93.74
Defines a static route on the NMS pointing to
the management interface of the edge switch
that provides access to the Fibre Channel
fabric.