HP 9124 - Cisco MDS Fabric Switch, Руководство по настройке

Страница: 171 / 1444

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
5-15
Cisco MDS 9000 Family CLI Configuration Guide
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 5 Initial Configuration
Assigning a Switch Name
Assigning a Switch Name
Each switch in the fabric requires a unique name. You can assign names to easily identify the switch by
its physical location, its SAN association, or the organization to which it is deployed. The assigned name
is displayed in the command-line prompt. The switch name is limited to 20 alphanumeric characters.
Note This guide refers to a switch in the Cisco MDS 9000 Family as switch , and it uses the
switch#
prompt.
To change the name of the switch, follow these steps:
Where Do You Go Next?
After reviewing the default configuration, you can change it or perform other configuration or
management tasks. The initial setup can only be performed at the CLI. However, you can continue to
configure other software features, or access the switch after initial configuration by using either the CLI
or the Device Manager and Fabric Manager applications.
To use the Cisco Fabric Manager, refer to the Cisco MDS 9000 Family Fabric Manager Configuration
Guide .
Verifying the Module Status
Before you begin configuring the switch, you need to ensure that the modules in the chassis are
functioning as designed.
To verify the status of a module at any time, issue the show module command in EXEC mode. A sample
output of the show module command follows:
switch#
show module
Mod Ports Module-Type Model Status
--- ----- ------------------------------- ------------------ ------------
2 8 IP Storage Services Module DS-X9308-SMIP ok
5 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 active *
6 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 ha-standby
8 0 Caching Services Module DS-X9560-SMAP ok
9 32 1/2 Gbps FC Module DS-X9032 ok
Mod Sw Hw World-Wide-Name(s) (WWN)
--- ----------- ------ --------------------------------------------------
2 1.3(0.106a) 0.206 20:41:00:05:30:00:00:00 to 20:48:00:05:30:00:00:00
5 1.3(0.106a) 0.602 --
6 1.3(0.106a)) 0.602 --
8 1.3(0.106a) 0.702 --
9 1.3(0.106a) 0.3 22:01:00:05:30:00:00:00 to 22:20:00:05:30:00:00:00
Command Purpose
Step 1
switch# config t
Enters configuration mode.
Step 2
switch(config)# switchname myswitch1
myswitch1(config)#
Changes the switch name prompt as specified
(myswitch1).
Step 3
myswitch1(config)# no switchname
switch(config)#
Reverts the switch name prompt to its default (switch#).