English
TEW-226PC/TEW-228PI Quick Installation Guide
V1.10 08182003
This Installation Guide will lead you through the installation of CardBus/PCI
Wireless Adapter and the configuration utility. To establish your wireless
network connection, the following steps should be executed.
1. Install the software using the installation CD.
2. Install the Adapter card in the computer.
3. Configure the Wireless Configuration Utility.
The product is designed to operate in Windows 98, Windows ME, Windows
2000, and Windows XP. And, the installation procedure for each operating
system is very similar.
Minimum Hardware Requirements
•
Computer with an available 32-bit CardBus or PCI slot
•
300 MHz processor and 32 MB of memory
(Recommended)
•
CardBus Controller properly installed and working in the computer
•
An 802.11b Access Point (for Infrastructure Mode) or another 802.11b
wireless adapter (for Ad-Hoc <Peer-to-Peer> networking mode).
(
Not required for driver and configuration utility installation)
<Important>
DO NOT install the adapter in the computer.
Please
follow the instructions below to install the driver and utility
before installing the adapter in the computer.
Installing the Driver and Wireless Utility for
Windows 98/ME/2000/XP
1. Insert the Driver & Utility CD-ROM into computer’s CD-ROM Drive and it
will automatically start a setup menu. Simply follow the instructions on
the screen to install the driver and the utility. If your computer does not
start the setup menu automatically, you can to run the software manually
by clicking on “Start”, choose “Run”, type
D:\autorun.exe
in the dialog
box (assuming
D:
drive is your CD-ROM drive) and click “OK”.
2. Click “Install Software” button, the InstallShield Wizard screen appears,
and then click “Next”.
Page
1
