HP ThinState Deploy
To perform an HP ThinState deployment, follow these steps:
1.
On the computer that will receive the captured image, set the boot order in Computer Setup to
USB boot
.
2.
Attach the USB flash drive, and then turn on the computer.
3.
Follow the on-screen instructions.
After you remove the USB flash drive and cycle power to the system, the image will unbundle. This
process can take 10 to 12 minutes. Do not interrupt or cycle power to the computer during this process.
You may use the captured image (flash.ibr) found on the USB flash drive in combination with Altiris
Deployment Solution and WinPE to remotely image multiple computers.
NOTE:
You must use flash.ibr in conjunction with the HP ThinState Deploy utility (e.g., ibrpe.exe).
Flash.ibr is not compatible with the Altiris rdeploy.exe or rdeployt.exe utilities. For additional information,
refer to the “HP Compaq Thin Client Imaging Tool” white paper at
http://www.hp.com/support
. For more
information about Altiris, go to the Altiris Web site at
http://www.altiris.com/
.
26
Chapter 4 Applications
Содержание 2533t - Compaq Mobile Thin Client
