Hoshizaki DCM-230FE, Руководство по обслуживанию

Страница: 51 / 54

51
7. REMOVAL AND REPLACEMENT OF ELECTRICAL SYSTEM
[a] BIN CONTROL (PROXIMITY SWITCH)
1) Unplug the ice dispenser.
2) Remove the Front Panel and Top Panel.
Note: The Proximity Switch is located on the outside of the Bin Top Panel.
3) Cut the leads at the wire connectors.
4) Remove the Switch Cover and the Proximity Switch.
5) Install the new Proximity Switch.
6) Replace the Switch Cover in its correct position.
7) Connect the leads of the Proximity Switch.
8) Plug in the ice dispenser.
9) To check the Bin Control operation, move the paddle located on the inside of the Bin
Top Panel. The Compressor should stop 90 sec. later, and the Gear Motor 150 sec.
later.
10) Replace the panels in their correct position.
[b] STARTER
1) Unplug the ice dispenser.
2) Remove the Apron Panel.
3) Remove the terminal cover of Compressor.
4) Disconnect the terminals from the Starter.
5) Remove the Starter.
6) Install the new Starter.
WARNING
The Starter is position-sensitive. Install it so that the arrow indication of the
Starter can point upward. Failing to install it in this way will cause abnormal
operation and adversely affect the Compressor operation as well.