25
7) Immerse the Agitator, Dispensing Auger, Bin Control Bracket Assembly, Spout,
Packing, Spout Cover, black Ice Dispensing Spout and Water Dispensing Nozzle in
the cleaning and sanitizing solutions for about 15 minutes respectively.
8) Rinse these parts thoroughly with clean water.
9) Wipe thoroughly the Shutter located above the Ice Dispensing Spout.
10) Reassemble the Bin Control Bracket Assembly.
11) Replace the Dispensing Auger and Agitator, Bin Control Bracket Assembly, Spout,
Packing, black Ice Dispensing Spout, Water Dispensing Nozzle and Spout
Cover in their correct positions.
12) Pour warm water into the Storage Bin to melt the ice produced from the cleaning
and sanitizing solutions.
13) Clean the storage bin liner, and rinse thoroughly.
14) Replace the Front Cover of the Storage Bin, the Top Panel and the Front Panel in
their correct positions.
[c] WATER VALVE
IMPORTANT
If the Filter in the Water Valve becomes clogged with sediment or dirt, the
water supply will be stopped and ice cannot be made. Disassemble the
Water Valve and clean out the Filter once every two months.
1) Unplug the ice dispenser
2) Close the water supply tap.
3) remove the panels.
4) Remove the Fitting Nut from the Water Valve. Do not lose the Packing.
5) Remove the Filter from the Water Valve, remove sediment or dirt and rinse it with
water.
6) Replace the Filter on the Water Valve.
7) Replace the Packing and secure it carefully with the Fitting Nut to prevent leakage.
8) Open the water supply tap.
Содержание DCM-230FE
