0
Unfolding:
Switch on the DrillManager Müller and raise
the machine.
With optional equipment: Unlock the safety
catch. Mind the lock. This must drop down,
to prevent relocking.
Depending on the hitched up machine, re-
move the safety catch bolts.
Switch on the hydraulic "Wing" function in
the display.
Unfold the machine.
When unfolding maintain the control unit under
pressure, so that the pressure accumulator on
the folding cylinder is preloaded with 100 - 120
bar.
Pressure gauge on seed hopper
Fan drive pressure
Preload pressure in wing hydraulics
Storage compartment
1.
2.
3.
3
1
2
Adjusting the wing cylinder on the seed
wagon:
Both wing frames are limited by stop screws on
the frame when unfolded.
In raised position both folding wings are slightly
hanging down. In this position the wing cylinder
must also be fully extended.
For repairs on the wing cylinder or in case of
uneven seed placement check the frame, if
necessary adjust the stop screws and then the
eye of the piston rod.
Unfold the machine;
Lift the wing frames with appropriate means,
until the wings are parallel or hang down up
to 0.5 cm.
Adjust the stop screws to contact.
Slacken the locking nut on the hydraulic cyl-
inder, keep turning the piston rod until piston
touches the inside of the cylinder, then turn
approx. half a turn further.
Tighten the locking nut again and check the
setting after one folding process.
