Honeywell RM640, Руководство пользователя

Страница: 100 / 184

6
OPERATION
100
RM640
www.honeywellprocess.com 34-VF-25-131 iss.1 GLO Feb 2019 US
•
[>>>>] to change the position of the
cursor.
•
[ ] to decrease the value (or move
the decimal point one digit to the
left) or [
] to increase the value (or
move the decimal point one digit to
the right).
•
[
^ ^ ^ ^
] to confirm.
Tank height. The distance from the flange
face / thread stop of the tank connection
down to the tank bottom. If the tank has a
dish-shaped or conical bottom, the tank
height is measured to a point on the tank
bottom directly below the antenna.
•
[ ] or [ ] for the selection of the
measurement name (Distance,
Level, Sensor Value or Reflection,
Volume (Mass), Ullage Volume
(Ullage Volume).
•
[
^
^ ^
^
] to confirm.
Current output 1 variable. The
manufacturer sets the current output
variable (for current output 1) to "Distance ”
before delivery.
If it is necessary to measure volume, ullage
volume, mass or ullage mass, refer to How
to configure the device to measure volume
or mass on page 109.
•
[>>>>] to change the position of the
cursor.
•
[ ] to decrease the value (or move
the decimal point one digit to the
left) or [
] to increase the value (or
move the decimal point one digit to
the right).
•
[
^ ^ ^ ^
] to confirm.
0% range. Use this step to give the 0%
output setting in the tank.
Refer to the illustrations that follow. When
menu item A4.1.3.1 Current Out. 1 Var. A4.1.3.1 Current Out. 1 Var. A4.1.3.1 Current Out. 1 Var. A4.1.3.1 Current Out. 1 Var. is
set to "Level", illustration
1
shows the
position of 0% output as a level above the
tank bottom. When menu item A4.1.3.1
A4.1.3.1 A4.1.3.1
A4.1.3.1
Current Out. 1 Var. Current Out. 1 Var. Current Out. 1 Var. Current Out. 1 Var. is set to "Distance",
illustration
2
shows the position of 0%
output as a distance below the flange facing
or thread stop of the process connection.
Screen Steps Description