Honeywell AlarmNet IGSMHS, Инструкция по установке и настройке, Страница: 7 / 64

Section 1: General Information
1-3
UL
– For the IGSMHS, only the V+ inverted, V– non-inverted, and EOL options have been
evaluated.
UL
Opening and Closing ring back is fully supported.
Zone Trigger Mode
 This mode is for use with control panels that do not support ECP communication nor
4204 Relay Modules
 The module provides six input zones and each zone can be configured for +V, -V, or
EOLR triggering.
UL
– For the IGSMHS, only the V+ inverted, V– non-inverted, and EOL options have
been evaluated.

Each zone can be programmed for inverted operation, delayed reporting, and restoral
reporting
 Zone 1 input can distinguish between pulsed and steady signals and report fire or
burglary alarms respectively
 Zone 1 can be programmed to report a LYNX panic (if used with LYNX control panel)
UL
– This feature has not been evaluated by UL.

Reports are sent in ADEMCO High-Speed format
UL
Opening and Closing ring back is supported by the control panel’s digital dialer.
4204 Mode and Two-4204 Mode

This mode is for use with Honeywell control panels that do not support ECP commu-
nication, but do support 4204 Relay Modules
 The module connects to the control panel’s keypad terminals
 The control panel treats the module as 4204 Relay Module(s), so program the control
panel accordingly, including setting the module’s proper 4204 device address

4204 mode provides up to four zone inputs, plus two optional trigger zones,
depending on options programmed
 Two-4204 mode provides up to eight zone inputs, depending on options programmed
 Each 4204 zone can be programmed for delayed reporting and restoral reporting

Reports are sent in ADEMCO High-Speed format
UL
4204 Mode and Two-4204 Mode has not been evaluated.
Module Supervision Features
The IGSMHS provides the following types of supervision and module fault detection:

Network communication failure: In the event the AlarmNet network does not hear a
supervisory message from the module within a specified time AlarmNet notifies the
central station of a communication failure.
 Communication path failure: In the event the module detects a communication path
failure, the control panel can be notified of a trouble condition with the module after
a specified time has elapsed.

Fault output: Terminal 11 can serve as a fail-safe trigger for module fault conditions.
 If used, the fault relay will trip when the following conditions occur: tamper * , power
loss * , low battery * , battery charger fault * , loss of network connectivity * , the
communication module is not registered and the communication module is remotely
disabled by AlarmNet.
* Alarm reporting for the noted conditions must be enabled for it to trigger the fault
relay.