94 • Section 5 — Equipment
Savoy SL & LX 5th Wheel & Travel Trailer
Entry door
The door uses two separate locks for personal safety and security. The door handle
incorporates a primary and secondary latching system. One locking system is the door
handle and the other is a dead bolt. However, keeping the entry door in good operating
condition requires some routine maintenance on a regular basis.
Adjustments
Adjustments can help maintain the entry door performance. These items are as follows:
Strike Plate Adjustment:
The door in the recreational vehicle was installed and adjusted
to a factory setting. The position of the striker plate may change over the course of time and
settlement of the recreational vehicle. The setting may need to be adjusted to insure that the
door operates smoothly and efficiently. To adjust the strike plate, loosen the two Phillips head
screws holding the plate to the jamb system. Move the plate in or out as needed to obtain a
proper seal closing force. Retighten the screws.
CAUTION:
If screws are loose on the out-swing doors, the backer plate will release and
drop down into the door jamb. Should this happen, replace the short screws
with a screw that is long enough to go through the jamb system and into the
frame work of the sidewall.
Locks:
The locking cylinder requires slight lubrication on an annual basis, or as needed. Use powdered
graphite, not a petroleum product. Petroleum products gum the cylinder and inhibit smooth operation. The upper
lock is the dead bolt, the lower lock is the privacy lock. Applying a light coating of white lithium grease to the
face of the lock bolt helps in retaining a smooth close.
Hinges:
The hinges for the door require slight lubrication annually, or as needed, with any high-quality, dry
spray lubricant.
Screen Door - Adjusting:
The screen door can be adjusted to sit flush in
the door jam. This requires two separate adjustments to be performed. The
first adjustment made is at the screen door latch/catch itself. Loosen the two
Phillips screws holding the latch to the door to permit vertical adjustment.
Move the latch far enough to catch on the striker mounted at the door frame.
Tighten both screws. The striker mount on the door frame permits horizontal
adjustment. Again, loosen the two Phillips screws holding the striker
assembly. Move the striker to center the latch and tighten the Phillips screws
in place.
Screen Door - Changing the Slider:
It is a simple procedure to replace the sliding cover. Place the slider in
the center. Pull from the center of the slider, it will bow enough to allow easy removal. To re-install, reverse this
procedure. Install the upper left corner first and pay attention to the location of the stop tabs.
020129b
020131c
020132b
Содержание Savoy LX 2006
