Holden Trailblazer Owner Manual (GMSA-Localizing-Australia - 10460368) -
2017 - crc - 6/29/16
76
Instruments and Controls
G
illuminates or flashes yellow.
Illuminates
Illuminates for a few seconds after
the ignition is switched on. If the
system is working normally, the
control indicator goes out.
If the indicator does not go out after
a few seconds, there is a fault in the
system. It is possible to keep driving
without Traction Control System
(TCS) activated.
Have the cause of the fault fixed by
a Holden dealer.
Flashes
During ESC, TCS and/or TSC
activation the DIC indicator will
flash.
See
. See
. See
Traction Control System
(TCS) Off Light
i
illuminates yellow.
Illuminates when the system is
deactivated.
See
Pre-Heat Light
.
When the ignition key is turned
ON,
K
illuminates and will stay
illuminated until the engine is
sufficiently warmed.
.
The preheating system switches
on only if the outside
temperature is low.
.
See
.
Tire Pressure Monitoring
System Light
7
For vehicles with the Tyre
Pressure Monitor System (TPMS),
this light comes on briefly when the
engine is started. It provides
information about tyre pressures
and the TPMS.
When the Light Is On Steady
This indicates that one or more of
the tyres are significantly
underinflated.
A Driver Information Centre (DIC)
tyre pressure message may also
display. See
.
Stop as soon as possible, and
inflate the tires to the pressure value
shown on the Tire and Loading
Information label. See
When the Light Flashes First and
Then Is On Steady
If the light flashes for about a minute
and then stays on, there may be a
problem with the TPMS. If the
problem is not corrected, the light
will come on at every ignition cycle.
See
Engine Oil Pressure Light
.
The
:
warning light
illuminates for a short time when
the ignition is turned on to show
that the light is working.