Holden Trailblazer Owner Manual (GMSA-Localizing-Australia - 10460368) -
2017 - crc - 6/29/16
Driving and Operating
189
{
Danger
Do not leave the key in position 1
or 2 for extended periods while
the engine is not running. This will
discharge the battery.
Do not turn the key to position 0
while driving. Driver could lose
control of vehicle and brake
power assistance would be
cancelled, causing vehicle
damage and risks of accident.
Starting the Engine
1. Apply the park brake.
2. Turn the key to position 1 while
moving the steering wheel
slightly to release the lock.
Manual transmission: Push the
clutch pedal to the floor and
move the selector lever to the
neutral position.
Automatic transmission: Move
the selector lever to
P
or
N
.
Do not accelerate.
3. Turn the ignition key to position
2 until
K
extinguishes.
4. Turn the key to position 3 and
release when the engine is
running.
Retained Accessory
Power (RAP)
The power outlets may be used
after the engine is turned off.
Note
The power outlets will continue to
operate for up to 10 minutes or until
a door is opened.
See
Starting the Diesel
Engine
Observe the following precautions to
ensure maximum turbocharger
service life.
.
After starting the engine, let it
idle for approximately 1 to
2 minutes (avoid acceleration or
driving the vehicle).
.
Do not stop the engine
immediately after high-load
driving (such as high-speed
driving or driving up steep
gradients). Let the engine idle
for approximately 1 to 2 minutes
to cool it down.
.
After changing the engine oil
and oil filter, start the engine and
let it idle for about 1 to 2 minutes
(avoid acceleration or driving the
vehicle).
.
Operate the engine above idle
speed only after normal engine
oil pressure has been
established. Forcing the
turbocharger to operate before