Holden Trailblazer Owner Manual (GMSA-Localizing-Australia - 10460368) -
2017 - crc - 6/29/16
262
Vehicle Care
{
Warning
As soon as possible after
changing a wheel, have the wheel
nuts tightened with a torque
wrench to 140 Nm (Newton
metres). Wheel nuts must be
tightened evenly to the correct
torque, as wheel nuts which have
not been tightened properly could
eventually allow the wheel to
come off while the vehicle is
moving.
28. Stow the replaced wheel, by
reversing Steps 8 to 13.
29. Stow the tools in the storage
compartment. See
.
30. Have the flat tyre renewed or
repaired.
When reinstalling the repaired
wheel:
1. Install the centre cap.
2. Place the cap on the wheel and
tap it into place until it is flush
with the wheel.
Jump Starting
Read the following warnings and
procedure in full before attempting
to jump start the vehicle.
If you are still unsure about jump
starting, Holden strongly
recommends for your safety and
that of the vehicle that you seek the
assistance of a suitably trained
service technician.
{
Warning
Do not push start or tow start the
vehicle. Therefore, if the battery is
flat, jump start, but do not push
start the vehicle.
Batteries produce explosive
gases, contain corrosive acids
and supply levels of electrical
current high enough to cause
burns. Therefore, adhere to the
following when working near a
battery:
(Continued)
Warning (Continued)
.
Do not attempt jump starting
directly from the battery in
the engine compartment.
.
Do not let the jumper lead
clamps touch each other or
other metal parts.
.
Do not allow the jumper
leads to contact any rotating
engine components.
.
Do not use open flames or
sparks near the battery.
.
Do not smoke near the
battery.
.
Never use a quick charger
to start the engine.
.
The battery must be
removed from the vehicle
for recharging.
.
Wear eye protection such
as safety glasses and avoid
leaning over the battery.
(Continued)
