Holden Trailblazer Owner Manual (GMSA-Localizing-Australia - 10460368) -
2017 - crc - 6/29/16
Vehicle Care
261
When positioning the jack
under the rear axle housing,
confirm that the slot on the
upper side of the jack fits on
the axle.
17. Set the jack to the necessary
height before positioning it
directly below the jacking point
in a manner that prevents it
from slipping.
{
Warning
Failure to position the jack as
described could cause the vehicle
to slip off the jack.
(Continued)
Warning (Continued)
Do not get under a vehicle that is
supported by a jack. No person
should place any portion of their
body under a vehicle that is
supported by a jack.
18. Attach the jack handle and with
the jack correctly aligned.
19. Rotate the handle until the
wheel is clear of the ground.
20. Remove the wheel nuts.
21. Exchange the wheel on the
vehicle with the spare wheel.
22. Remove any rust or dirt from
the wheel nuts and studs,
mounting surfaces and spare
wheel.
{
Danger
Never use oil or grease on bolts
or nuts as the nuts may come
loose. The vehicle wheel could
fall off and may lead to serious
injury or death.
23. Put the wheel nuts back on
with the rounded end of the
nuts towards the wheel.
24. Tighten each wheel nut by
hand, then use the wheel
wrench to tighten the nuts until
the wheel is held against
the hub.
25. Lower the vehicle by reversing
the jacking procedure.
26. Remove the jack from under
the vehicle.
27. With the wheel on the ground,
use the wheel wrench to
tighten the wheel nuts in a
crosswise sequence.