Hofmann geodyna 7300, Руководство по эксплуатации

Страница: 90 / 128

90
7-2
7-1
4 5 6
10
7 8 9
Trouble shooting
7.1 System messages
The wheel balancer can send messages to the
operator. relevant to errors (E codes) or warnings (H
codes). The codes will be described in the following
chapters.
Whenever a code appears:
•
Make a note of it.
•
Look up the code in the list below. If the code is not
described, call service team.
•
Perform the steps described.
In special cases, or if the need arises, some operating
modes or states can be changed by entering the
appropriate codes (C Codes).
7.1.1 C Codes
Selecting and changing a code.
Example for code C0 (Fig. 7-1)
— Press and hold down together the “ STAR ” (7) and
“ FINE ” (8) keys for 5 seconds.
The C codes selection condition appears ( Fig. 7-2 ).
— Press one of the “ + ” (4) or “ - ” (6), keys until the
readout shows the desired code number (e.g.: C
0).
— Press the ENTER key (5) to acquire the selection.
The right number readout shows the current state, e.
g.: “
0 ”, witch in this case means switched off.
If the desired state is already on the readout:
— Press the STOP ( key 10, Fig. 7-1 ) once to return
to theC codes selection ( Fig. 7-2 ), twice to exit
and return to the operating mode.
If the desired state is not that shown by the readout,
but needs selecting, proceed as follows:
— Press one of the “ + ” or “ - ” keys until the right
readout shows the desired condition (e.g.: “ I ”).
Now two options are possible:
Option 1
—
Press the ENTER key to acquire the selection.
— Press the STOP key to return to the operating
mode.
The operating mode change is complete and is saved
until a new setting is entered. When the machine is
switched off the settings are not deleted, and at each
subsequent start-up they appear as previously set up
until changed again
or,
..
..
..
.
..
.