60
5-32
5-33
1
2
3
4
5
Operation
5.11.3 Start optimisation/weight
minimisation
Optimisation program cycle
The following is a description of the optimisation
(identifi ed with OP) or weight minimisation (identifi ed
with UN) program cycle.
Optimisation cycle
Figure 5.-32
If after the measuring run the right or left compensation
and/or the static unbalance is more than 30 grams,
immediately perform optimisation. To activate this
function press
FINE
(
3
) +
ENTER
(
1
).
•
Before optimisation, check that the rim dimensions
have been set correctly.
You cannot correct the data later.
•
Demount the tyre and clamp only the rim for the
compensation run.
•
Press
ENTER
(
1
).
Indication
OP.1
appears (
Fig. 5-33
).
•
Rotate the rim so that the valve is exactly
perpendicular to and above the main shaft.
•
Press
ENTER
(
1
) to acquire the valve position.
Indication
OP.2
appears.
Repeat the operation to correct a wrong valve
positioning.
Weight minimisation
If no optimisation, but only weight minimisation (i.e.
without compensation run for the rim without tyre),
proceed as follows:
•
Clamp the complete wheel (rim and tyre).
•
Press
FINE
(
3
) and
ENTER
(
1
) if minimisation is
started separately from optimisation.
Reading
OP.1
appears.
•
Press
FINE
(
3
) to go to the minimisation program.
Reading
Un.3
appears. Run the minimisation program.
•
With program
OP.2
the rim compensation run can
still be omitted. Go to the program by pressing the
FINE
(
3
) key.
Reading
UN.4
appears.
•
Proceed with the minimisation program.
The valve position entered in
OP.1
is automatically
acquired.
..
..
..
.
..
.
Содержание geodyna 7300
Страница 116: ...116 Blank Page ...
Страница 126: ...126 Blank Page ...
Страница 127: ...127 Blank Page ...
