Hofmann geodyna 7300, Руководство по эксплуатации

Страница: 78 / 128

78
5-43
5-44
Operation
5.12.2 Anti-skid function
On wheels with a limited weight, skid detection may
make it impossible to perform a measuring speed run.
This function may be disabled for a single launch:
•
Hold the Enter key down while the wheel guard is
lowering.
5.12.3 Weight Unit Toggle Mode
Basic setting of weight unit: grams.
Select this mode to change the unit of measurement
of the weight before or after carrying out a balancing
operation.
•
Select the “ * ” key until the weight unit indicator
fl ashes.
The “oz” indicator will start fl ashing.
The display is now as in
Figure 5-43 .
•
Select Return .
The weight setting status will toggle (from grams to
ounces or from ounces to grams).
The program returns to the main menu.
5.12.4 Dimension Unit Toggle Mode
Basic setting of the unit of measurement for diameter
and width: inches.
Select this mode to change the units of measurement
of the diameter and width before or after carrying out
a balancing operation.
•
Select the “ * ” key until the indicator of the units of
measurement of the dimensions blinks.
The “mm” indicator will start fl ashing.
The display is now as in
Figure 5-44 .
Note : Make sure that all the preset PAX units
have been removed. The operator can
now select the units in steps of 1 mm if
the mm mode has been selected.
•
Select Return .
The status of the diameter and width dimension
units will toggle (from inches to mm, or mm to
inches).
Offset is always measured and shown in millimetres.
The program returns to the main menu.
..
..
..
.
..
.
ounces.