CTC-CEN Service Manual 07-13 Rev.E
14
Check wires continuity from power supply plug to main
switch wires terminals.
IMPORTANT! TO CHECK GROUND (YELLOW/GREEN) WIRE, DISCONNECT THE WIRE END FROM THE
TERMINAL BLOCK.
TO REPLACE THE CABLE:
Disconnect the power supply wires from the plug and switch teminals.
Disconnect the ground wire from terminal block.
Release cable strain relief from the inverter box.
Remove plug from cord and take the defective cable away.
Insert the new cable through the strain relief.
IMPORTANT! USE ONLY APPROVED CABLES, PLUGS. GROUND WIRE MUST BE LONGER THAN THE
OTHER ONES.
Fix new faston on inside cable ends and connect them to the switch terminals and to the plug.
Fix the main switch to the electronic box.
Install the disc.
Mount again the switch knob and cover of the screw.
Connect the ground wire to ground terminal block.
Install
plug.
Tighten strain relief
FIRMLY
.
Plug the machine to the wall.
Check if the machine works fine.
Fix the inverter box again to the cabinet.
5.2 MAIN ROTARY SWITCH Q1 # 2-15359A: CHECK AND REPLACEMENT
:
0,5h
:
Allen keys of 3 and 5mm, small and medium screwdriver, medium cross screwdriver, faston pliers, scissors,
pliers, multimeter
:
Defective main switch may cause the following malfunction:
1. Turning the switch on the machine does not run at all.
2. Turning the machine on the building main switch shuts off.
TO CHECK THE SWITCH:
Disconnect power supply.
Remove the switch from the electronic box
5.1
Disconnect all wires from the main switch and remove it with a
screwdriver.
Turn switch to “Off”. Check that there is no continuity (
Ω
=infinity)
between any terminals 1,2,3 and 4.
Turn switch to “On”. Check that there is continuity between
terminals 1-2 and 3-4 (
Ω
= 0 ~ 0,3) and discontinuity between terminals
1-3 and 1-4, as well as 2-3 and 2-4
If there is continuity the switch is in short circuit. It must be replaced.
Содержание ATC 900
