CTC-CEN Service Manual 07-13 Rev.E
65
Lock the counter nut.
Release the pedal.
Now turn the linkage and the nut to set the clearance at about 8mm between the two nuts.
Lock the nut to the linkage.
Lock the valve to the pedal with the collar.
Plug in the air pressure.
Pressing half of spool valve pedal the air has to come out from the inflator only.
Pressing the spool valve pedal all way down the air has to come out from the inflation hose and from the bead
seating jet at the same time.
Install the foot pedal assembly cover.
7.20 BEAD BLASTER VALVE # 1-29581A AND AIR TANK : CHECK AND REPLACEMENT
:
1h
: End key 12mm, big pliers.
: Defective bead blaster valve may cause the following malfunction:
1.
No air from air jet.
2.
Air leaking from diaphragm.
TO CHECK THE BEAD BLASTER VALVE:
Verify if it is leaking air from the diaphragm.
Verify it the bead seating jet is leaking air.
TO REPLACE THE BEAD BLASTER VALVE:
Disconnect the air pressure.
Remove
the
hoses.
Remove the valve from the tank niplex.
Mount the new valve to the niplex.
Install the hoses.
Plug the air pressure and check if it works fine again.
7.21 AIR CONTROL # EAA0350G54A: CHECK AND REPLACEMENT
:
30’
: End key 8, 7 and 14mm, 4mm allen key.
: Defective bead blaster valve may cause the following malfunction:
1.
The valve does not stop the tire inflation.
2.
The valve does not inflate the tire at all.
3.
The valve leaks air.
TO CHECK THE VALVE:
Take a deflated wheel and inflate it.
If the valve will show one of the above issue, it must be replaced.
Содержание ATC 900
