Hofmann ATC 900, Руководство по обслуживанию

Страница: 77 / 120

CTC-CEN Service Manual 07-13 Rev.E
77

Connect the tool finger arm to the ball joint.

If the holes are not matching, turn the ball joint until they will match.

Tighten the bolt firmly.

Lower the finger completely: make sure that when the cylinder and tool finger will reach their end of stroke at
the same time.

In case it need a fine adjustment turns the piston rod shaft only.

Lock the upper ball joint nut.

Check if the machine work fine.
TO ADJUST THE VERTICAL TOOL CLEARANCE:

Block a 17” rim diameter rim in good condition to the centre post.

Unlock the front screws and tighten all way down and then turn
them backward of two turns each one.

Lock the counter nuts.

Place the tool on the rim, as normal operation, and then lock it.

Make sure that the clearance between plastic protection and rim is
2mm.

If the clearance is higher, release the arm, unlock the screws and
tighten them accordingly. Then lock the screws again.

If the clearance is lower, release the arm, unlock the screws and
loosen them accordingly. Then lock the screws again.

Check if the machine works fine