CTC-CEN Service Manual 07-13 Rev.E
85
TO ADJUST THE DISC INCLINATION:
Remove the counter setscrews from the bead breaker holder.
To adjust the inclination of the disc in rest position, turn the upper
set screw.
To adjust the inclination of the disc in second stage turn the lower
setscrew.
Secure the setscrews with the counter setscrews and Loctite.
Mount the protection.
Check if the machine works fine.
8.9 BEAD BREAKER DISCS CLEARANCE: CHECK AND ADJUSTMENT
:
30’ each one
:
Allen keys 4, 5 and 6mm, 8 and 17mm end keys, 13mm tube type key.
:
Incorrect bead breaker discs clearance may cause the following malfunctions:
1. Bead breaker arms misalignment.
2. Bead breaker arms not synchronized.
3. Bead breaker arms beeper beeps when arms are blocked.
TO CHECK THE DISC CLEARANCE:
Block a 17” rim in good condition to the center post.
Position the bead breaker disc in contct to the rim and block it, as normal operation.
Make sure that the clearance in between the disc and the rim will of 1mm.
TO ADJUST THE DISC CLEARANCE:
Remove the rear protection.
Содержание ATC 900
