CTC-CEN Service Manual 07-13 Rev.E
64
Loosen the screws to take out the defective valve.
Install the new valve and plug the air hoses.
Connect the air pressure again.
Adjust the lowering and raising cylinder speed by turning the two adjustable
exaust valve.
Mount the control valve cover.
Check if the machine works fine again.
7.19 BEAD INFLATING VALVE # EAA0329G75A: CHECK AND REPLACEMENT
:
1h
: Allen key 4 and 5mm, 8,10 and 13mm key.
: Defective inflation spool valve may cause the following malfunction:
1.
Air
leaking.
2.
No inflating action.
3.
Air leaking from the blaster jet.
TO CHECK THE SPOOL VALVE:
Open the foot pedal assembly.
Check if the mechanical components (springs, screws and linkage) are fine.
Verify if the valve is leaking air from the rear springs when the pedal is in rest position.
Verify if the valve is leaking air from front locking nuts when the pedal is in rest position.
TO REPLACE THE SPOOL VALVE:
Disconnect the air pressure from the machine.
Turn the machine off.
Unplug the hoses.
Remove
the
collar.
Loosen the three bracket screws.
Take the defective valve assy out and bolt the new one.
Plug the hoses
Press the pedal until it become hard to be pushed.
Turn the nuts to set the clearance at about 4mm between the nut and the bracket.
Содержание ATC 900
