CTC-CEN Service Manual 07-13 Rev.E
78
TO ADJUST THE VERTICAL ROD BLOCKING PLATE:
Press the yellow button valve to lower completely the vertical tool rod.
Tighten as much as possible the vertical blocking cylinder
adjustment screw in order to block the rod.
Pull the yellow button valve all towards the operator in order to lift
the vertical tool rod.
Turn counter clockwise the vertical blocking cylinder adjustment
screw until the vertical rod will move upward.
Then perform some rod lowering and raising operations to make
sure that the rod is moving smoothly.
Block the counter nut.
TO ADJUST THE VERTICAL ROD BLOCKING PLATE SPRINGS:
Block the vertical rod.
Check if the spring are completely compressed.
Содержание ATC 900
