Hioki 3532-50, Инструкция по эксплуатации

Страница: 183 / 198

169
_____________________________________________________________________________________________
7.4 Options
______________________________________________________________________________________________
NOTE
NOTE
7.4 Options
9518-01 GP-IB INTERFACE
Compliance standard: IEEE-488.1 (1987)
Reference standard: IEEE-488.2 (1987)
For explanation of how to fit the 9518-01 GP-IB INTERFACE BOARD and
for a detailed description of its commands etc., reference should be made to
the user manual supplied with the 9518-01.
9593-01 RS-232C INTERFACE
Compliance standard: EIA RS-232C
For explanation of how to fit the 9593-01 RS-232C INTERFACE BOARD
and for a detailed description of its commands etc., reference should be
made to the user manual supplied with the 9593-01.
9140 4-TERMINAL PROBE
This is a crocodile clip type of test probe.
This type of probe is very convenient for
connection to a wide range of wires, from
comparatively thin wires to comparatively thick
ones.
Range of frequencies which can be used is from
DC to 100 kHz
Open and close by holding the clip part of the 9140. If you hold the cable
when opening or closing the clip, too much stress may be added to the cable,
causing it to break.
9143 PINCHER PROBE
This tweezer type probe is very convenient for
testing samples such as chips. The impedance
range which can be measured by the 3532-50 using
this probe varies according to the frequencies.
The range of test frequency which can be used is
from DC to 5 MHz.
When using a probe, it may happen that the values obtained vary because the
contact resistance is altering due to alterations in the pinch pressure exerted.
Therefore it is necessary to keep the pinch pressure as constant as possible.