Hioki 3532-50, Инструкция по эксплуатации

Страница: 13 / 198

v
_____________________________________________________________________________________________
______________________________________________________________________________________________
WARNING
Before turning the product on, make sure the source voltage
matches that indicated on the product's power connector.
Connection to an improper supply voltage may damage the product
and present an electrical hazard.
To avoid electrical accidents and to maintain the safety
specifications of this instrument, connect the power cord provided
only to a 3-contact (two-con ground) outlet.
To avoid electric shock, do not remove the instrument's case. The
internal components of the instrument carry high voltages and may
become very hot during operation.
CAUTION 
Various connectors are present on the outside of the 3532-50. Never
connect any cable to any of these connectors without first turning off the
power supply and removing the power cord. Moreover, check the
connections carefully in order to avoid any chance of setting up a short
circuit etc..

If anything unusual happens during operation of the unit, turn off the
power switch immediately and contact any HIOKI service facility for help,
advice and service.

This product should be installed and operated between 0 and 40 and
80% RH or less, and less than 2000 m height.

The unit should always be stored in a range of temperature and humidity
from -10 to 55 , 80% RH or less.

Do not store or use the product where it could be exposed to direct
sunlight, high temperature or humidity, or condensation. Under such
conditions, the product may be damaged and insulation may deteriorate
so that it no longer meets specifications.

To avoid damage to the product, protect it from vibration or shock during
transport and handling, and be especially careful to avoid dropping.

Do not use excessive force on the touch panel, and do not use sharp
objects that could damage the touch screen.

Before using the instrument, make sure that the insulation on the probes
is undamaged and that no bare conductors are improperly exposed.
Using the instrument in such conditions could cause an electric shock, so
contact your dealer or Hioki representative for repair.

Ventilation holes for heat radiation are provided on the side panels of the
product. Leave sufficient space around the ventilation holes and install
the product with the holes unobstructed. Installation of the product with
the ventilation holes obstructed may cause a malfunction or fire.
Points for Attention During Use
Follow these precautions to ensure safe operation and to obtain the full
benefits of the various functions.
About the guarantee
You should be aware that HIOKI cannot accept any responsibility directly or
indirectly if the unit has been incorporated in some other system, or if it is
resold to a third party.