Hilti DST 10-CA, Руководство по эксплуатации

Страница: 42 / 52

38 English 2328079
*2328079*
8.3.2 Installing water bypass
1. Remove the screw plug from the water bypass connection (1) .
2. Screw the water-connection adapter into the water bypass connection (2) .
3. Use a ring/open-ended wrench to tighten the water-connection adapter hand-tight
(3) .
4. Connect the water drain hose to the water-connection adapter (4) .
8.3.3 Installing blade guard and dust extractor
1. Install the BG 65 blade guard (dry cutting).
2. Connect a suction hose to each dust removal connector on the blade guard (1) .
3. Install the suction channel at the back of the cut (2) and connect a dust extractor (3) .
9 Dismantling the saw system
9.1 Removing saw blade (normal cutting)
1. Remove the blade guard.
2. Pivot the saw arm into the 12 o’clock position.
3. Switch the saw off at the on/off switch and press the EMERGENCY STOP button.
4. Disconnect the supply cord plug from the power outlet.
5. Slacken the clamping screw of the outer flange and remove the outer flange.
▶
Make sure that the saw blade does not drop off the centering spigot after the outer
flange is removed.
6. Remove the saw blade from the centering spigot.
7. Secure the outer flange to the inner flange with the clamping screw.