Hilti DST 10-CA, Руководство по эксплуатации

Страница: 35 / 52

*2328079*
2328079 English 31
2. Press the flange nut fully into the inner flange (1) .
The inside face of the flange must form a flat surface. Install the flange only if
the flange nut is fully countersunk. Attempting installation with the flange nut
protruding can result is damage to the inner flange and mount.
3. Insert the inner flange into the 6 shouldered guide bushes of the saw arm (2) .
▶
The shoulder of each shouldered guide stud is seated in the groove in the inner
flange.
4. Push the tie rod into mount (3) and tighten the tie rod by hand (4) .
5. Counter-hold the tie rod in the inner flange with the carrier tool for flush-cut saw
blades and tighten the tie rod by hand (5) until it is seated.
▶
If tightening by hand is not possible, use a ring/open-ended wrench.
• Tightening the tie rod draws the flange nut out of the parked position into the
inner flange, so that it slips into the mount of the saw arm arbor. When the
flange nut slips into the mount of the saw arm arbor the tie rod becomes easy
to move and spring tension can pull it back to the initial position.
At least 6 full turns are necessary for correct installation of the inner flange.
• IMPORTANT!
If the tie rod does not turn readily after about 3 full turns, the splines might
not be in correct alignment and the flange cannot be installed correctly.
→ Abort installation.
→ Remove the inner flange, eliminate the cause of the difficulty and re-install
the inner flange.
6. Tighten the tie rod to the specified torque.
Technical data
Ring/open-ended wrench (for tie rod) 19 mm
Tightening torque 80 Nm
7. Check that the inner flange is seated flat and with zero play on the saw arm arbor.
7.4.2 Installing saw blade (normal cut)
Before starting installation, switch the wall saw off at the on/off switch or press the
EMERGENCY STOP button.
Disconnect the supply cord plug from the power outlet.
Always use the genuine Hilti M12×25 10.9 clamping screw to secure the saw blade.